![]() If Location Services permissions are not granted or if there are no valid coordinates, Lunar will try an IP Geolocation service like Lunar will ask for Location Services permissions when you first launch it, and will fetch your last coordinates to compute the sun position throughout the day. If you use your monitors in a room with lots of natural light, Location Mode might be a good choice. Lunar will recompute the curve based on these manual adjustments so that it will be completely automatic after a few daysĪdapt the brightness of your monitors based on the sun position in the sky.You can also use the sliders to do this.In multi-monitor setups you can move the cursor to that display and use Shift+ Brightness Up/Down to control it.Whenever a target display feels darker/brighter than it should be, adjust it until it's back in sync with the source.Reset the Algorithm curve on all displays from the Controls menu.Follow the steps below for getting the brightness curves right for each monitor.Set the Adaptive setting to Lunar for all the targets from the Controls menu.Set the rest of the monitors as a Sync Target in Lunar. ![]() Set the Adaptive setting to System for the source from the Controls menu.Set the source as a Sync Source in Lunar.Otherwise, prioritize Studio Display and Pro Display, followed by LG Ultrafine and the rest.If you use a MacBook, the built-in display is always the most responsive source. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |