![]() Go down to the lower right corner of the custom graph screen and click on one of the presets. It's easy enough to tweak a little here and there and you will likely need to do so again when Spring/Summer rolls around. Wherever the temp peaks out, set a reasonable fan speed - something you can tolerate. Best thing to do is play or do what you normally do. If you are putting 600W through a 4090, you are going to make a lot of heat. The average increase for a typical user is somewhere around +10C, but this is very GPU and load dependent. It's really hard to give you a range, but obviously wherever it is at when you boot the system and let it sit for normal tasks for 10-15 minutes is the baseline. The top fans can pull too much of the GPU heat through the radiator when you'd prefer it left via the rear exhaust.įront and rear fan on the temp probe at the back. You may even want to prevent it from over-reaching during gaming. You don't need maximum speed and this will take of itself. You've got 3x140 and a lot of radiator surface area. Leave the radiator fans on H170i Temp (coolant temperature). Lastly, if I do use that rear sensor as the sensor for my fan curve, do you have any suggestions on setting up a curve based on that? When adjusting a sensor based on say my CPU temps, I have a good understanding of where I would want that curve, but I not so much for a sensor placed in the rear of my case by a fan, haha. My CPU does run quite hot, as it is a 13900k, but the AIO is pretty beefy, so I thought cooling everything by the case temp would be a good middle ground for cooling both CPU and GPU. If I set those fans to use that rear exhaust sensor, do you think that would work pretty well for this type of setup? I'm trying to find a balance between cooling my GPU and my CPU. But wanted to change the other case fans to help with the GPU. I was planning to keep the AIO on the water coolant sensor. The 3 front case fans, and the 4 120mm side fans are all intake. See how it works like this, case with gpu temp, AIO with water temp.Īctually, no, I have the AIO as a top exhaust. ![]() It's probably best to leave the AIO on water temp though, or else it will be hard to make its fans accelerate when the cpu alone is working. the case fans will bring plenty of air for the gpu. You could set the case fans to be controlled by that exhaust sensor since it will mostly see the GPU heat. I assume you have the H170 as front intake □
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |